Bosch 06033D0000 Notice Originale page 12

12 | English
(3) Battery charge indicator
(4) Battery a)
(5) Motor housing
(6) Dust container
(7) Extension tube
(8) Holder for crevice nozzle/brush
(9) Brush
(10) Crevice nozzle
(11) Floor nozzle
(12) Battery bay
(13) Battery release button
(14) Flexible extension tube a)
(15) Coarse dirt filter
(16) Filter
(17) Recess
(18) Filter seal
(19) Wall bracket
a)
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical Data
Cordless dry vacuum cleaner
Article number
Container volume (gross)
Max. vacuum pressure
Max. flow rate
Weight according to EPTA-Pro-
cedure 01:2014
Permitted ambient temperature
– while charging
– during operation A) and during
storage
Recommended batteries
Recommended chargers
A) Limited performance at temperatures <0 °C
Technical data determined using the battery that comes with the
product.
Assembly
Battery Charging
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your power tool.
1 609 92A 7UP | (30.05.2022)
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your power tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep discharge
by the "Electronic Cell Protection (ECP)". A protective circuit
switches the cordless dust extractor off when the battery is
drained.
u
The battery must be removed from the vacuum cleaner to
charge it.
The battery features NTC temperature monitoring, which
only permits charging in a temperature range between 0 °C
and 45 °C. This achieves a long battery life.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.
Battery charge indicator
The three green LEDs of the battery charge indicator (3) in-
dicate the state of charge of the battery (4). The battery
charge indicator only illuminates for three seconds after
EasyVac 12
start-up.
3 603 CD0 0..
LED
l 0.38
Continuous lighting 3 x green
kPa 5.3
Continuous lighting 2 x green
m /min 1.2
3 Continuous lighting 1 x green
kg 1.0
Flashing light 3 x green
If no LED lights up after switching on, the battery is defective
and must be replaced.
°C 0 to +45
Inserting and removing the battery (see figures A1 – A2)
°C –20 to +50
u
PBA 10.8 V ...
– Slide the battery (4) all the way into the battery bay (12).
PBA 12 V ...
– To remove the battery (4), press the release buttons (13)
AL 11..
GAL 12..
GAL 12V-...
Fitting the vacuum cleaner accessories
(see figure B)
u
The vacuum cleaner accessories can be directly connected
with the dust container (6).
See the illustration for the different ways of combining the
vacuum cleaner accessories.
Do not continue to press the on/off switch after the
tool has been automatically switched off. This can
damage the battery.
Do not use force to insert the battery. The battery is de-
signed in such a way that it can only be inserted into the
vacuum cleaner when it is in the right position.
on the battery and pull it out of the battery bay (12).
Remove the battery before cleaning or performing
maintenance on the dust extractor, making tool ad-
justments, changing accessories or placing the dust
extractor in storage. This safety measure prevents the
dust extractor from being started accidentally.
Capacity
≥ 2/3
≥ 1/3
< 1/3
Reserve
Bosch Power Tools