Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A
ssembly
To assist you in identifying
components of your vacuum,
the parts have been numbered
as follows:
1 Handle section, upper
2 Tube, lower
3 Power head
4 Outer bag
5
5 Paper filter dust bag
6 Power cord
7 Retaining spring
8 Bag tension bar
9 Zip fastener
10 On/off switch
11 Cord hook
12 Connector assembly
13 Fan housing
1
2
Upper
Handle
Connector
Assembly
E
N
9
1
11
4
12
2
7
10
13
8
3
Before assembling appliance,
remove two screws from the
connector assembly. Remove
cardboard insert by pulling
upward.
Slide upper handle section over
matching section of the connector
assembly. Insert short screw into
top hole and long screw into the
bottom hole then tighten firmly until
handle is no longer loose.
G
L
I
S
H
O
perating
To Operate
Make sure disposable paper filter dust bag is in place. DO NOT operate
the cleaner without a paper filter dust bag. Plug the power cord into an
electrical outlet and press the On (l) - OFF (O) switch on top of base
when ready to operate.
General Information
The performance of your new cleaner greatly depends upon care and
maintenance. The instructions in this manual will guide you in performing
basic care and maintenance. To obtain the most satisfying years of
service read the instructions and keep them handy for future reference.
Operating Recommendations
6
This new ORECK XL High-Speed Upright is one of the finest, fastest, and
strongest units in its class. You'll love the way it cleans, gets under things,
and it's SO lightweight and easy to use.
The following are a few simple suggestions regarding its operation:
1. When inserting a new disposable paper filter dust bag—FIRST PUFF
OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or makes an
unusual noise, STOP OPERATION and service.
4. Although your upright will pick up pins, paper clips, and other small
objects, it is recommended that these be removed from the floor
before you vacuum. Failure to do so may result in permanent
damage to the motor suction fan and its housing.
5. WARNING: Do not use your vacuum cleaner on damp or wet
surfaces. This will cause damage to the vacuum cleaner and is
dangerous to the user. Damage caused by use on wet or damp
surfaces is not covered under warranty.
6. REPLACE THE BELT EVERY 6 MONTHS.
7. Change the disposable filter dust bag at least once a month—even
if it is not full! The collected dust in the dust bag can cause odor,
attract moisture, act as a breeding area and can affect the
efficiency of the cleaner.
8. DO NOT run the vacuum cleaner over cord. The revolving brush
could damage the cord.
9. Use caution when vacuuming over area rug edges and fringe.
Disposable Paper Filter Dust Bags
Disposable paper filter dust bags play a very important role in the
efficiency of your ORECK vacuum cleaner. The purpose of the paper bag
is to trap dirt, but at the same time it must be porous enough to allow air
to pass through. If the paper bag becomes clogged, no air can pass
through the cleaner and cleaning cannot take place, regardless of the
cleaner's power.
To keep your cleaner operating at maximum efficiency, change the dust
bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE
DUST BAG.
Be sure the disposable paper filter dust bag is installed properly.
All paper dust bags are not the same. Your ORECK
disposable dust bags have been designed to be used with
the ORECK cleaner. Using bags other than genuine ORECK
TYPE CC disposable bags will affect the cleaning ability of
your cleaner and could cause damage to it.
4
I
nstructions
Publicité
Table des Matières
