Assembly; Operating Instructions - Oreck XL U2000R-1 Guide D'utilisation

A
ssembly
To assist you in identifying components of your vacuum, the parts
have been numbered as follows:
1 Handle section, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter
dust bag
6 Power cord
7 Retaining
spring
8 Bag tension
5
9 Zip fastener
10 ON/OFF
switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector Assembly/
Rear Carry Handle
14 Fan housing
15 Cord assembly
16 Cord-Lock
17 Pigtail
1
E N
17
10
9
1
12
13
4
bar
2
7
8
14
3
Before assembling
appliance, remove two
screws from the connector
assembly. Remove plastic
insert by pulling upward.
G L I S H
Upper
2
Handle
Connector

Assembly

11
3
16
6
15
O
perating
To Operate
Make sure disposable paper filter dust bag is in place. DO NOT
operate the cleaner without a paper filter dust bag. Plug the
power cord into an electrical outlet and press the ON (l) - OFF
(O) switch on Helping Handle Assembly, or on top of base for
Straight Handle Models when ready to operate.
General Information
The performance of your new cleaner greatly depends upon
care and maintenance. The instructions in this manual will guide
you in performing basic care and maintenance. To obtain the
most satisfying years of service read the instructions and keep
them handy for future reference.
Operating Recommendations
The following are a few simple suggestions regarding its
operation:
1. When inserting a new disposable paper filter dust bag—
FIRST PUFF OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or
makes an unusual noise, STOP OPERATION and service.
4. Although your upright will pick up pins, paper clips, and
other small objects, it is recommended that these be
removed from the floor before you vacuum. Failure to do so
may result in permanent damage to the motor suction fan
and its housing.
5. WARNING: Do not use your vacuum cleaner on damp or
wet surfaces. This will cause damage to the vacuum
cleaner and is dangerous to the user. Damage caused by
use on wet or damp surfaces is not covered under
warranty.
6. REPLACE THE BELT EVERY 6 MONTHS.
7. Change the disposable filter dust bag at least once a
month—even if it is not full! The collected dust in the dust
bag can cause odor, attract moisture, act as a breeding
area and can affect the efficiency of the cleaner.
4
With ON/OFF switch facing
the front of the unit, slide
upper handle section over
matching section of the
connector assembly. Place
brace against handle and
connection assembly
aligning the holes. Insert one
screw into top hole and one
screw into the bottom hole
then tighten firmly until
handle is no longer loose.
Attach cord to cord clip by
pressing cord above and
below clip ensuring the cord
is fully rested in clip.
I
nstructions