Reset; Lamp Servicing Count Down - Secomam UviLine Connect Série Manuel Utilisateur

9.4

RESET

<HOME>
– [General setup]
- Reset
It is possible to reset (initialize) the measurement settings or all settings.
Remark
The reset function is only available for users belonging to the user group « Administrator ».
There are different possibilities to reset the instruments settings.

Reset configuration

Lamp counter

Internal DataB folder
9.5

LAMP SERVICING COUNT DOWN

The photometer counts the operating hours of the lamp. The information on the operating hours of the lamp is given
in the Info menu.
The number quoted there corresponds to the number of measurements.
After the lamp was exchanged you should reset the lamp counter (previous section).
UviLine Connect Series
All settings are deleted except the memory which
contains measurements results, methods defined by the
user and the measured blank values.
Allow to reset to zero the service lamp counter after the
lamp changing
All memory results stored in local application folder
(DataB) will be erased
- 70 -