Publicité
Les langues disponibles
Les langues disponibles
5.
Reinstall outer washer and tighten blade
stud finger tight. The face of outer washer has
marks on it that will help you properly adjust the
blade stud. Press lock button to lock shaft and
tighten blade stud counter-clockwise one mark on
blade washer with the wrench provided.
Do not use wrenches with longer handles, since it may
lead to over-tightening of the blade stud.
Battery Charging
To charge your tool`s battery,use only charger and
battery pack ( model:B0P-SP17-18 ) provided with
your tool.Using other batteries can lead to injuries
and pose a fire hazard.
!
WARNING
To prevent personal injury, always position vacuum hose
so that it does not interfere with the lower guard, or the
cutting operation at all settings.
FIG. 2
BLADE
SHAFT
LOWER
GUARD
UPPER
GUARD
INNER WASHER
Large Diameter
Faces Blade
WRENCH
MARK
LOWER
OUTER
GUARD
WASHER
SPRING
BLADE
OUTER WASHER
Large Diameter
Faces Blade
BLADE
STUD
TIGHTEN
LOOSEN
21
OPERATION
Depth adjustment
Disconnect battery pack from tool. Loosen the depth
adjustment knob located on the back side of the upper
guard. Hold the foot down with one hand and raise or
lower saw by the handle. Tighten knob at the depth
setting desired. Check desired depth (Fig. 3). Not more
than one tooth length of the blade should extend below
the material to be cut, for minimum splintering (Fig. 4).
FIG. 3
DEPTH
ADJUSTMENT
CALIBRATED
KNOB
DEPTH
BRACKET
Switch
The safety switch is designed to prevent accidental
starting.To operate safety switch, press the lockoff button
(4) with your thumb on either side of handle to disengage
the lock, then press the trigger (11). When the trigger is
released the button will engage the safety switch
automatically and the trigger will no longer operate
(Fig.5).
FIG. 5
SAFETY SWITCH
LOCK OFF
BUTTON
TRIGGER
0
O
cutting angle check
Disconnect battery pack from tool. Set foot to maximum
depth of cut setting. Loosen bevel adjustment knob, set
to 0
O
on quadrant, retighten knob and check for 90
between the blade and bottom plane of foot with a square
(Fig. 6). If adjustment is necessary, tilt foot to 45
tighten bevel adjustment wing nut and bend "TAB" with
an adjustable wrench or pliers (Fig. 7).
FIG. 4
ONE TOOTH LENGTH SHOULD
PNETRATE WOOD FOR
MINIMUM SPLINTERING
O
angle
O
,
Publicité
