Simpson SCGH5500 Guide D'utilisation Et D'entretien page 8

Follow the steps outlined in this section to unpack and assemble your generator. If you have
any questions regarding the unpacking or assembly of your generator, please have your
model number and serial number ready, then contact customer support at 1-877-362-4271
or email cservice@fna-group.com.
Unpacking
1. Place the shipping carton on a solid, flat surface.
2. Carefully cut the top of the carton open.
3. Carefully cut each corner of the carton from top to bottom.
4. Lay each side of the carton flat on the ground.
5. Remove everything from the carton.
Installing the Wheels -
Slide the axle through the wheel, the first washer, frame mounting hole, and the second
washer. Then insert the clip through the hole in the axle to secure the assembly. This
process must be done on both sides of the generator.
NOTE: Generator wheels are not intended for over-the-road use.
1
1. Clip
2. Washers
3. Wheel
4. Axle
Page 6
ASSEMBLY
SCGH5500, SCGH8500(E)
2 3 4