Publicité
Les langues disponibles
Les langues disponibles
Connecting Battery (Electric Start Models Only)
Batteries contain sulfuric acid. Sulfuric acid is highly corrosive. Contact with skin can cause
severe burns; contact with eyes can cause permanent blindness; and accidental ingestion
can cause death. To avoid contact with sulfuric acid, always wear protective equipment
when handling batteries. If acid contacts skin, flush are with cool water for 10-15 minutes.
Immediately remove contaminated clothing and thoroughly wash the underlying skin.
Always remove the black, negative (-) battery cable first and always connect the black,
negative (-) battery cable last. Failure to do this could cause metallic tools to short to the
frame possibly causing burns or the battery to explode.
SCGH8500E
The battery included with the generator is a 12-volt, 11Ah, garden tractor style battery.
To connect the battery, you will need to install the battery cables by following the steps
outlined below.
1. Remove battery terminal covers (if applicable).
2. Connect red cable (1) to the positive (+) battery
terminal with supplied bolt and nut.
3. Connect black cable (2) to the negative (-)
battery terminal with supplied bolt and nut.
4. Make sure both the positive and negative
connections are secure.
5. Slide the rubber boots over both terminals
and connection hardware.
SCGH10000E
The battery included with the generator is a 12-volt, 36Ah, "U1" style battery. To connect
the battery, you will need to install the battery cables by following the steps outlined below.
1. Remove the cover from the battery box.
2. Carefully place the battery into the battery box.
3. Place the red, positive (+) battery cable (1) onto
the positive (+) battery post. Tighten.
4. Place the black, negative (-) battery cable (2)
onto the negative (-) battery post. Tighten.
5. Place the cover back onto the battery box.
Page 10
WARNING:
WARNING:
WARNING:
WARNING:
ACID
BATTERY CONNECTIONS
1
1
2
2
Publicité
