Simpson SCGH5500 Guide D'utilisation Et D'entretien page 35

Problem
Generator has no output
Problem
Engine will not start
For more information refer
to the engine manual.
Page 33
TROUBLESHOOTING
Generator Troubleshooting Chart
Possible Causes
Circuit breakers are off
Device or cord failure
Generator needs service
Engine Troubleshooting Chart
Possible Causes
Engine control switch is in
the OFF position.
Choke not set correctly
Fuel not reaching
Spark plug in bad condition
Engine needs service
Empty fuel tank
carburetor
Low engine oil
Fuel old or stale
Solutions
Unplug all devices
and reset all the circuit
breakers to the
ON position
Unplug device and check
the cord and the device for
damage or
lose connections.
Take to an authorized
service center.
Solutions
Turn the engine control
switch to the ON position.
Set the choke per the
OPERATING CHECKLIST
section of this manual
Add fuel to tank per the
OPERATING CHECKLIST
section of this manual.
Turn the fuel valve to the
ON position
Check the oil level and fill
as needed per the
engine manual.
Inspect, clean, set gap, or
replace the spark plug per
the engine manual.
Remove stale fuel and
replace it with fresh fuel.
Take to an authorized
service center.