Simpson SCGH5500 Guide D'utilisation Et D'entretien page 24

SCGH5500, SCGH8500(E)
1. Check oil with generator on a level
surface and the engine off.
2. Unscrew the engine oil dipstick and pull it
out, then wipe dipstick clean.
3. Place clean dipstick into filler neck but do
not thread it in, leave it to rest on the filler neck.
4. Remove the dipstick from filler neck and
check oil level. Oil level should be between
the upper and lower oil limits on the dipstick.
5. If level is low, add the recommended oil to
the crankcase until the level reaches the
upper limit on the dipstick. See the engine
manual for recommended oil.
6. Install the dipstick and tighten cap by
threading it into the filler neck.
SCGH10000E
1. Check oil with generator on a level
surface and the engine off.
2. Fully pull the engine oil dipstick out then
wipe the dipstick clean.
3. Place the clean dipstick fully into the
dipstick tube.
4. Remove the dipstick and check oil level.
Oil level should be between the upper and
lower oil limits on the dipstick.
5. If level is low, add the recommended oil to
the crankcase until the level reaches the
upper limit on the dipstick. See the engine
manual for recommended oil.
6. Place the dipstick fully into the dipstick tube.
Page 22
Upper Oil Limit
Lower Oil Limit
Upper Oil Limit
Lower Oil Limit