Wolf Garten EXPERT 37 E Notice D'instruction D'origine page 13

Operation
General
z Please check noise abatement regulations prevailing in your
country.
z Please feed cable through the strain relief
3
Note: WOLF-Garten Flick-Flack®
WOLF-Garten Flick-Flack® keeps the cable away from the
L
cutting unit .
M
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
z Switch off motor and pull out power plug.
1. Pull the lever out (1).
2. Set the desired cutting height (2).
3. Press the lever back in (3).
z If possible, mow when grass is dry in order to protect turf. Do
not se cutting position too low when mowing very hight or wet
grass.
z We recommend an average cutting height of 40 mm.
z The mower operates from any normal household mains sup-
ply, provided with a 16 Amps. fuse.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
z We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
z Retrofit kits are available for old installations. Consult an
electrician.
z Switch on motor with mowerplaced on level and firm ground.
z not in high grass - alternatively tilt slightly
O
1. Depress button and hold (1).
2. Lift up bar (2).
3. Release bar (1).
z Raise drive bracket (3).
z Release drive bracket (3).
G
K
K .
N .
O
/ A 400 EA
O
O
z Release bar (2).
z To prevent strips of grass from being left unmowed, the cutting
paths must always overlap a few centimeters
z Always let cable trail on the cut side of the lawn.
Cut / Collect
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Do not start the motor until your feet are at a safe
distance from the cutting tool.
1. Remove the grass collecting bag.
2. Turn the switch to "CUT/COLLECT".
3. Hang up the collection bag if necessary.
4. Start the motor.
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Do not attach the collection bag until your feet are at a
safe distance from the cutting tool.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the reces-
ses (see arrow).
3. Replace the protective flap.
When the collection bag is full, the flap lowers by itself.
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Switch off motor and pull out power plug.
z Empty collection bag.
z Remove potential blockages in the cutting space before
starting.
3
Instructions for level indicator:
For an efficient functioning of the level indicator, regularly
clean the holes under the level indicator in the collection
bag with a hand brush.
P
.
Q
R
S
13