STERWINS 82278984 Notice De Montage, Utilisation Et Entretien page 208

FR
ES
Connecting the suction hose
PT
it with appropriate tool.
IT
• As a basic principle, we recommend using:
foreign bodies.
EL
- A suction-hose set with suction hose and an intake valve with a strainer (in order to prevent long
priming periods).
• If you cannot obtain a suction-hose set, please purchase :
PL
- an 25 mm (1") intake hose
- an intake valve with a strainer
- 2 hose clamps 2 standard adapters (one for the suction hose, one for the discharge line) and assemble
RU
the suction-hose set yourself using a standard adapter and a clamp.
KZ
4.3 FIRST USE
UA
RO
EN
Connecting the suction hose
• Screw the standard connectors onto the suction connector.
• Assemble the suction hose using a standard connector and clamp. Make sure the assembly is tight
enough as a leaking suction hose will draw in air instead of water.
CAUTION ! Always wear safety glasses and gloves during
installation.
illustration 2.3
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under subheading
therein before using this product.
illustration 2.5
Risk of damage to the pump!
cause damages to the pump. Any damage caused in this way
will not be covered under our warranty
Risk of damage to the pump!
The hose adapters on the suction and discharge connectors
must only be tightened by hand to avoid damage to
connectors. If water leaking at the connector, seal the joint
with PTFE tape (not included).
208
U
R
E