Gladiator GANA04CKMX Instructions D'assemblage page 8

5. Connect the Wall Cabinet(s) to the Wall
NOTE: This instruction is for attaching the wall cabinet directly to
the wall. For attaching the wall cabinet to Gladiator
channels, please refer to page 12.
IMPORTANT: The M6 x 40 hex tapping bolts should be drilled
into a wall stud.
X 1 per Cabinet
Wall
P6
X 2 per
Cabinet
F2
Wall
Find the wall studs and
bolt the bracket to as
many studs as possible
by using the M6 x 40
hex tapping bolts.
The distance between the locker's top and bracket's bottom
■
edge should be 4-7/8".
The distance between the locker and bracket should be 2".
■
The distance between brackets should be 3-7/8".
■
8
ASSEMBLY INSTRUCTIONS
GearTrack
®
2"
3-7/8"
5.08 cm
9.84 cm
4-7/8"
12.38 cm
Location of the
wall mounting
bracket:
P6
F2
Wall
Cabinet
Mounting
Bracket
Hang the wall cabinet onto
the mounting bracket
6. Connect the Wall Cabinet(s) to the Adjoining
Cabinets
®
IMPORTANT: The M6 x 40 hex tapping bolts should be drilled
into a wall stud.
NOTE: This is an example to show you how to build your system
by connecting multiple cabinets (sold separately).
X 4 per
connection
F1
X 4 per
connection
F3
X 4 per
connection
F4
X 2 per
Wall
F2
Cabinet
Wall
Connect the wall cabinets as shown and tighten securely with
■
four M6 x 16 hex socket head screws (F1), four nuts (F3) and
four washers (F4) for each side.
Attach each wall cabinet's bottom to the wall studs with two
■
M6 x 40 hex tapping bolts (F2).
F3
F4
F1
F2