Gladiator GANA04CKMX Instructions D'assemblage page 15

INSTALL CABINET TO GLADIATOR
Install the 24" 1-drawer 2-door
Base Cabinet
NOTE: Gladiator
Flex Brackets are sold individually and
®
Gladiator GearTrack channels are sold separately.
® ®
1. Install the wall brackets to the cabinet.
X 2
P6
F3
F5
P6
Remove the drawer from the base cabinet. (See instruction on
■
Page 16)
Temporarily turn the base cabinet upside down as shown.
■
Attach the brackets to the back of the base cabinet as shown
■
with eight M6 round head square neck bolts (F5) and eight M6
flange nuts (F3).
CHANNEL
X 8 X 8
F5 F3
Two brackets
required as
shown
bracket's orientation
during assembly
GEARTRACK
®
2. Hang the base cabinet onto the
GearTrack channels.
®
The GearTrack channels should be installed
®
with the spacing as shown.
Make sure the two brackets are fully engaged in the slots
■
as shown. Install the drawer back to the base cabinet. (See
instruction on page 16)
NOTE: For installation of the Gladiator
please refer to the manual instructions included with the
Gladiator GearTrack channels.
® ®
®
27"
27"
( 68.58 cm)
GearTrack channels,
® ®
15