AENO EK8S Guide De Démarrage Rapide page 8

 On the control panel of the kettle, press and hold the power button until
the 2 indicators (7) and (8) start flashing and the device beeps three times.
 In the application on the "Connection instructions" screen check the "The
indicator is blinking" box. Click "Next".
 Wait until the message "Device added successfully" appears.
Note: The device can also be controlled via voice assistants. Detailed
information is available in the Installation and Operation Manual at
aeno.com/documents. If the connection fails, make sure the device is
connected to a power source and turned on, check the Wi-Fi router settings
at aeno.com/router-help, remove the kettle from the stand, put it back on
the stand, and then repeat the connection process.
Descaling
Frequency: Once a month (hard and very hard water) or once every 2–3 months
(water of medium hardness or soft) when using the kettle 3–5 times a day.
Limescale remedies and cleaning methods
Table vinegar
Pour 0.5 l of vinegar (6 % or
9 %) into the kettle, leave for
1 h without boiling. Pour out
the contents, wash the
kettle and boil and drain the
water 5–6 times
Troubleshooting
 The device does not turn on. Possible cause: There is no power coming
from the power outlet. Solution: Test the outlet by plugging another device
into it.
 The kettle switches off a few seconds after it is switched on. Possible cause:
low water level in the kettle. Solution: Turn off and unplug the device. Wait
for the kettle to cool down and follow the instructions under "Boiling" in
the "Operating the device" section.
8
Citric acid
Boil 0.5 l of water. Add
25 g of citric acid and
leave for 15 min. Pour out
the contents, wash the
kettle and boil and drain
the water 5–6 times
Special descale
Follow the
manufacturer's
instructions on
the package
aeno.com/documents