AENO EK8S Guide De Démarrage Rapide page 6

water to reduce limescale buildup. Use the kettle for heating water only. Do
not allow children to use the kettle unsupervised. Do not open the kettle
while it is boiling or during the first few minutes after boiling. Be careful when
pouring boiling water, do not tilt the kettle with boiling water too sharply.
Make sure the lid is closed before you lift the kettle. Do not pour water below
the MIN mark and above the MAX mark on the inside of the housing. Use the
device only with the supplied stand. Unplug the unit when not in use and
before cleaning.
Preparing the device for operation
Before using the kettle for the first time, fill the kettle to the MAX mark. Boil
and drain the water. Wipe the outer and inner surfaces of the kettle with a
damp cloth. Allow it to dry. Make sure there is no moisture left on the stand
and the kettle.
Operating the device
Controlling the device via the control panel
Function
Boiling
Maintaining the
set water
temperature
after boiling for
24 hours
6
Actions
 Fill the kettle with water by removing the kettle from
the stand, opening the lid by pressing the button on
the top of the handle, and draw the desired amount of
water.
 Close the lid tightly and place the kettle on the stand.
 Plug the power cord into a power outlet.
 Press the power button (6) on the device panel. The
indicator (7) will light up. After the water boils, the
device will beep three times and go into standby mode
 Fill the kettle with water (see instructions in section
"Boiling").
 Press the power button (6), the indicator (7) will light
up and the boiling process will start.
 During the boiling process, use the "+/-" button (9) to
aeno.com/documents