Bosch Vision 300 Serie Notice D'utilisation, D'installation Et De Maintenance page 9

D Ifspace isveryrestricted, itis
recommended to fittheinitial p arts
oftheexhaust ductto thedryer
before thedryerismoved toits
final i nstallation location.
DONOT pushagainst thedryer
doorglass.Risk ofbreakage!
De not
push against
the d0or glass!
9. Move the dryer to its final location.
Do not slide dryer across the
floor if height-adjustable feet
have been extended. Feet and/or
dryer base may be damaged if
dryer is slid across floor with
height-adjustable feet extended.
10. Position and then level the dryer.
I
LJ :[
The dryer should be level with all four
feet firmly on the ground. The dryer
must not wobble. If the dryer is not level
or if it does wobble, the feet must be
adjusted. Adjust the height-adjustable
feet using the 1 in. (25mm) wrench until
the dryer does not rock and is level,
both front-to-back and side-to-side.
After making preliminary
adjustments, press down on each
corner of the dryer to make sure
the unit does not wobble. If
pressing down on a corner causes
the dryer to wobble, lower the
dryer foot on that corner until the
foot touches the floor firmly.
Install the dryer and level it from side to
side and front to back. Use a bubble
level. Never remove the
height-adjustable feet!
11. Connect the exhaust duct to the
exhaust air outlet on the dryer (see
page 16).
12.
13.
14.
15.
Insert the dryer electrical plug into
the wall receptacle (see page 14).
Open the shut off valve.
Read the operating instructions to
understand how your dryer
operates. (see page 20).
Conduct an appliance test:
Check that the drum is empty.
Close the dryer door.
Switch the dryer to "Extra Dry"
and then press the
"Start/Pause" button.
After 3 5 minutes press the
"Start/Pause" button and open
the door.
If the interior of the dryer feels
warm, the dryer has been
connected properly.
Switch the dryer to "OFF".
If the dryer does not work,
switch the dryer to "OFF".
Look in the troubleshooting
section (page 30) and find the
fault.
Door Hinge Reversal
The door is hinged on the right hand
side of the dryer at the factory. The
door hinge can be reversed if
necessary.
Turn off the gas supply if the
dryer must be moved Ln order to
reverse the door hinge. Follow
the gas uninstall andreinstall
directions found in the "Checklist
for Installation" (see page 8).
Tools Needed
T20 star head screwdriver
Hinge Reversal Parts
Hinge (with 4 white plastic bushings)
Hinge Cover Plate
Door Assembly
Hinge Reversal Procedure
1. Unplug the dryer.
2. Prepare a firm, fiat, padded
surface to lay the dryer door on
while changing the hinge.
3. Open the dryer door to fully
expose the hinge cover.
4. Remove the 4 screws holding the
hinge cover in place.
remove
four
screws
Set the cover aside along with the
four screws for later reinstallation.
9