Berger RC2 1200 Manuel D'utilisation page 26

GB
8 Warranty
Every Berger product is thoroughly checked and tested before it leaves the factory. The
statutory warranty period is two years and begins with the purchase of the appliance. Please
provide proof of purchase (receipt, invoice, delivery note, etc.). Please keep these documents
in a safe place. If the appliance needs to be repaired, take it to your specialist dealer or send it
to them.
For repair and warranty processing, please include the following documents when you send in
the device:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
9 Troubleshooting
Problem
The cooler does not work.
IN DC mode: The cooler
is not working (plug is
inserted).
In AC mode:
The cooler is not working
(plug is inserted).
In gas mode:
The cooler is not working
(to cooler is connected to
the gas).
The cooler does not start
up after a long period of
inactivity.
26
Possible cause
The cooler has not been set up properly.
The refrigerant circuit is defective.
No voltage is flowing from the DC power
socket in your vehicle.
The DC socket is dirty. This results in a poor
electrical contact.
The fuse of the DC plug has blown.
The vehicle fuse has blown.
No voltage present in the AC socket.
The cooler is not properly connected to the
gas.
–
Suggested remedy
Check if the device is horizontal.
Check if the ventilation of the device is sufficient.
This can only be repaired by an authorised repair centre.
The ignition must be switched on in most vehicles to supply
current to the DC power socket.
If the plug of your cooler becomes very warm in the DC
socket, either the socket must be cleaned or the plug has not
been assembled correctly.
Replace the fuse of the DC plug with one of the same rating.
Replace the vehicle fuse in the DC socket (usually 15 A)
(Please refer to the operating manual of your vehicle).
Try using another plug socket.
Check if the gas supply is in full working order.
Check if the valve on the gas bottle is open.
Check if there is still gas in the bottle.
Check if several energy sources are connected at the same
time.
Hold down the cooling level con-troller longer to ignite the
flame.
Disconnect the device from the power supply, turn it upside
down and wait for five minutes.
Turn the cooler the right way up again and switch it on again.