Télécharger Imprimer la page

Berger RC2 1200 Manuel D'utilisation page 20

Publicité

Les langues disponibles
  • FR

Les langues disponibles

GB
• Children shall not play with the device.
• Cleaning and user maintenance shall not be made by children without supervision.
• Children aged from 3 to 8 years are allowed to load and unload cooling devices.
Explosion hazard
• Do not store any explosive substances such as spray cans with a flammable propellant in
the cooling device.
CAUTION! Failure to obey these cautions could result in minor or moderate injury.
Electrocution hazard
• Before starting the cooling device, ensure that the power supply line and the plug are dry.
• Disconnect the cooling device from the power supply
– before each cleaning and maintenance
– after every use
Health hazard
• Please check if the cooling capacity of the device is suitable for storing the food or
medicine you wish to cool.
• Only use the appliance where there is good ventilation.
• Do not let the appliance operate unattended.
• Only operate the cooler from a single energy source.
• Food may only be stored in its original packaging or in suitable containers.
• Opening the cooling device for long periods can cause significant increase of the
temperature in the compartments of the device.
• Clean regularly surfaces that can come in contact with food and accessible drainage
systems.
• Store raw meat and fish in suitable containers in the device, so that it is not in contact with
or can drip onto other food.
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mould developing within the device.
NOTICE! Damage hazard
• Check that the voltage specification on the type plate corresponds to that of the energy
supply.
• Only connect the cooling device as follows:
– DC outlet: Only use cables with an appropriate cross section.
– AC outlet: Only use the AC cable supplied
• Never pull the plug out of the socket by the cable.
• If the cooling device is connected to a DC outlet: Only select DC operation (battery mode)
if you are using a battery monitor or if the alternator in your vehicle provides sufficient
voltage.
20

Publicité

loading