LaserLiner MultiWet-Finder Plus Mode D'emploi page 22

11.1 Setting the wet limit
C
MENU
C
REF
CM
MAX
CM
CAL
CM
INDEX
The wet/dry LED indicator is programmed in line with the relevant material
characteristics so the LEDs also provide information about whether the material
should be classified as dry, moist or wet. Holding down the 'MODE' button
and the 'MAX SET' button at the same time takes you to the menu. Pressing
the 'MAX SET' button allows you to set the dry limit only in INDEX mode. This
limit value must be established away from the specific point of use. As soon
as Building material mode is selected, the LED display appears based on the
saved material parameters.
11.2 Alarm / LED display
C
MENU
C
REF
CM
MAX
CM
CAL
CM
INDEX
22 EN
MENU
REF
MAX
CAL
MENU
REF
MAX
CAL
Pressing the 'MODE' button allows you to switch
C
the acoustic alarm and the wet/dry LED display
MENU
C
REF
on and off.
CM
MAX
CM
CAL
CM
INDEX
C
C
CM
CM
CM
INDEX
C
C
CM
CM
CM
INDEX
WET
limit
C
MENU
C
REF
CM
MAX
CM
CAL
CM
INDEX