Geberit SIGMA80 Mode D'emploi page 15

Make settings with the Geberit App
The following settings can be made with a Geberit app:
• Set the light colour of the buttons
• Set the function of the button illumination
• Activate cleaning mode
• Deactivate automatic flush actuation
Skilled persons can find additional settings in the maintenance manual, art. no. 970.779.00.0.
Troubleshooting
Malfunction
Incorrect flushes (too soon,
too late, unwanted)
Water is running continuously
into the ceramic pan.
The ceramic pan is not being
flushed out properly.
A flush is triggered when you
step back from the WC
without manual actuation.
Buttons are flashing red.
Button illumination switches
on when approached, but
flushing cannot be triggered.
Button illumination does not
switch on when approached,
and flushing cannot be
triggered.
Button illumination does not
switch on when approached,
but a flush can be triggered.
9007208999056779 © 04-2022
970.778.00.0(02)
Cause
Actuator plate dirty or wet
Scratched actuator plate
Software fault
Technical fault
Flush volumes set incorrectly ▶ Contact a skilled person.
Ceramic pan is blocked with
limescale
Automatic flush actuation
activated
The WC flush control waits
until all objects (tools, people,
curtain, etc.) are outside of
the user detection range
(approx. 1 m in front of the
actuator plate). The envir-
onment is then re-evaluated.
Software fault
Technical fault
Power failure
Technical fault
Button illumination
deactivated
Rectification
▶ Clean or dry the actuator
plate.
▶ Contact a skilled person.
▶ Interrupt the power supply
(mains fuse) for
10 minutes.
▶ Contact a skilled person.
▶ Descale the ceramic pan.
▶ Deactivate automatic flush
actuation with the Geberit
app.
▶ Remove objects from the
user detection range.
▶ Interrupt the power supply
(mains fuse) for
10 minutes.
▶ Contact a skilled person.
▶ Check the power supply
(mains fuse).
▶ Contact a skilled person.
▶ Activate button illumination
with the Geberit app.
EN
15