emerio WK-111746 Mode D'emploi page 6

WK-111746
HOUSEHOLD USE ONLY
PARTS DESCRIPTION
1. Lid
2. Lid knob
3. Filter
4. Water gauge
5. On/off switch button (A) and temperature
control button (B)
6. Handle
7. Power base
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling
a full kettle of water twice and then discarding the water.
OPERATION OF YOUR KETTLE
1. Open the lid by pulling up the lid knob; fill with the desired amount of water to the water kettle. Always
fill the kettle between the minimum and maximum marks. Too little water will result in the kettle
switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before connecting the power cord to the outlet.
Connect the plug into a power outlet. Press the on/off switch button "
2.
starts to boil the water. The LED lights inside the kettle will illuminate red. The kettle will switch off
automatically once the water has boiled. You can shut off the power by pressing the switch button again
at any moment during boiling water.
NOTE: Ensure that the lid is firmly closed.
3. Take the plug out of the outlet. Lift the kettle then pour the water.
NOTE: operate carefully when pouring the water from your kettle as boiling water will scald.
4. The kettle will not re-boil until the switch is pressed again. Allow to cool for 30~40 seconds before
reopening to boil water.
NOTE: Ensure power supply is turned off when kettle is not in use.
5. Should you accidentally allow the kettle to operate without water; the boil-dry protection will
automatically switch it off. If this occurs, allow the kettle to cool before filling with cold water and
re-boiling.
- 5 -
" on the handle and the kettle
EN