English
19.2
Cutting blades
– Tooth spacing: 34 mm
– Cutting length: 600 mm
– Sharpening angle: 45°
19.3
STIHL AP battery
– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
®
– Bluetooth
radio interface (only for batteries
with
):
– Data connection: Bluetooth
mobile appliance must be compatible with
®
Bluetooth
Low Energy 5.0 and support
Generic Access Profile (GAP).
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
– Mobile appliance operating system require‐
ments: Android or iOS (current version or
higher)
19.4
Temperature limits
WARNING
■ The battery is not protected against all ambi‐
ent conditions. If the battery is exposed to cer‐
tain environmental conditions, it may catch fire
or explode. This may result in serious injury to
people and damage to property.
► Do not charge the battery below -20°C or
above +50°C.
► Do not use the hedge trimmer or battery
below -20°C or above +50°C.
► Do not store the hedge trimmer or battery
below -20°C or above +70°C.
19.5
Recommended Temperature
Ranges
For optimum performance of the hedge trimmer
and batteries, observe the following temperature
ranges:
– Charging: +5°C to +40°C
– Use: - 10 °C to + 40 °C
– Storage: - 20 °C to + 50 °C
34
®
5.1. The
20 Spare Parts and Accessories
If the battery is charged, used or stored outside
the recommended temperature ranges, perform‐
ance may be restricted.
If the battery is wet or moist, allow the battery to
dry for at least 48 h between 15°C and 50°C and
with less than 70% humidity. Higher humidity
may extend the drying time.
19.6
Sound Values and Vibration
Values
The K-value for the sound pressure level is
2 dB(A). The K-value for the sound power level is
2 dB(A). K-value for vibration level is 2 m/s².
STIHL recommends wearing ear defenders.
– Sound pressure level L
to EN 62841-4-2: 76 dB(A).
– Sound power level L
EN 62841-4-2: 84 dB(A).
– Vibration value a
hv
EN 62841-4-2:
– Control handle: 0.8 m/s².
– Loop handle: 1.0 m/s².
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
tools. The vibration levels actually occurring may
vary from the values indicated, depending on the
type of application. The vibration levels indicated
can be used for an initial estimate of the vibration
stress. The actual vibration stress has to be esti‐
mated. The times can be taken into account in
the estimate when the electric power tool is
switched off and also when it is switched on but
running without any load.
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
19.7
REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
20 Spare Parts and Accesso‐
ries
20.1
Spare parts and accessories
These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
measured according
p
measured according to
wA
measured as per
0458-020-9602-A