KERN KIB-TM Mode D'emploi page 41

Now enter the IP address for the PC on the display unit:
 Menu item "P9Prt"  "oPt""riP_1-4" (IP address PC: 192.168.1.104)
 Connect KIB-TM to network (router/switch).
 Start Balance Connection
 Start Expert mode (See chap. 2)
How to add interface:
- Click on "Add" (green +)
- Click on "TCP/IP Server"
- Tab "IP Port Properties"
Set "TCP – Server listening/waiting"
How to set port:
The settings must match the settings
of the KIB-TM:
"P9Prt"  "opt"  "rPort"
The port must be set to "8080" or
"6000".
It must not be blocked by the router.
Click Apply, close window.
Enable port:
Right-click  Open console
 Data will be transferred
(The console is merely used to check
data transmission). All other output
methods can only be set in Balance
Connection.)
• If data transmission is not happening, check the settings described above and re-
enter as required.
• Restart of KIB-TM is required after making changes to WLAN
settings.
• After the restart it may take up to 20 sec until the WLAN module is
displayed.
KIB-TM-ZB-e-1913 15