KERN KIB-TM Mode D'emploi page 33

1.4 KERN Communications Protocol (KERN Interface Protocol)
KCP (KERN communication protocol) contains the commands that are used to
control the KERN balances via the interface.
• Menu setting P2 Com  Mode  ASK
• Menu setting P2 Com  PTYPE  KCP
• Finish commands with CR/LF character.
• Consult the KCP manual for more information, available on
our KERN website (www.kern-sohn.com).
The following commands are supported:
@
I0
I1
I2
I3
I4
˽ ˽
I4 A "xxxxxxxx"
I5
S
SI
SIR
Z
ZI
D
˽ ˽
D " "
K
SR
T
MM
TAC
TI
Polling-Intervall
• The time between periodic inquiries or when sending requests
(queries) by the interface must be longer than 100 ms.
KIB-TM-ZB-e-1913
Cancel
List all implemented KCP commands
Query KCP level and KCP versions
Query device information (type, capacity)
Query device software version
Query serial number
Set serial number (default value is K123456)
Query SW-Identification number
Send stable weight value
Send weight value immediately
Send weight value immediately and repeat
Zero
Zero immediately
Display: Write text to display
Clear Display (after D-Command)
Keys: Set configuration
Send weight value on weight change (send and repeat)
Tare
Query/preset tare weight value
Clear tare value
Tare immediately
7