Publicité
Les langues disponibles
Les langues disponibles
EN
The battery charge decreases during use.
c. Place the vacuum cleaner next to a power socket.
d. Connect the charger (12) to the power socket.
e. Insert the male connector (20) in the socket on the charge base (9) or directly in the motor
body (4) socket (5).
f. Make sure that the connector (20) is inserted in the appliance body socket (5).
After a few seconds the LEDs turn on displaying battery charge status.
Note:
-
The vacuum cleaner can remained connected to the charger permanently without any
risk.
The charger slightly heats up: this is a perfectly normal phenomenon.
-
To charge the vacuum cleaner again after use is advised so that it's always available, com-
pletely charged and so that you could benefit optimally from its aspiration performances
and from its autonomy.
-
However, it's preferable to disconnect it in case of a long absence (holidays...) as an au-
tonomy decrease caused by self-discharge could occur.
-
If the appliance is not used for more than a month, fully charge it and then disconnect
the power adapter. Repeat the operation at least every 3 months.
-
When the battery is almost completely empty, proceed to recharge it. Avoid draining the
battery completely.
Do not attempt to disassemble the appliance and / or batteries.
It's dangerous !
USE AS ELECTRIC BROOM
-
Remove the male connector (20) from the socket (5).
-
Place one foot on the brush (11) and hold the handle (1).
Pull the latter towards yourself to adjust inclination as desired.
-
Press the ON/OFF switch (2) to start the motor.
-
Press the -/+ switch (2a) to adjust the speed.
-
Press the ON/OFF switch (2) to turn the motor off.
44
BATTERY CHARGING
(Fig.F4)
(Fig.F4)
(Fig.F5)
VVC 9023
Publicité
