Good Earth Lighting SE1400-BP2-07LF1-G Mode D'emploi page 8

Verify light works
6
ON
Restore power to the junction box and verify the
wiring is correct.
Add the plug
7
Insert the translucent silicone plug into the
center mounting hole.
The fixture has a built-in light sensor that prevents the motion sensor or area light from activating
during daylight hours. Once the power has been turned on, the fixture needs around 20 to 30 seconds to
warm up. The light will turn o after around 20 seconds, then the light will go to the SetToGo factory presets
(50ft. detection range, 3 minute light activation.)
Set to
ATTENTION!
8
Direct Wire Installation
How the Controls Work
FACTORY PRESETS
SetToGo: The security light is PRESET at the factory with
the following settings:
Range: 50 feet
Minutes: 3 min.
(duration)
If these settings are acceptable for your needs, you don't need
to do anything more with the SetToGo settings except to do the
actual electrical installation of the fixture.
To change the factory SetToGo default settings, follow the
instructions below.
IMPORTANT
"ON" position first. During daylight hours, it
may be necessary to block the light from
the sensor head by blocking the light from
it by covering it with a dark towel or sock.
This will enable the light to activate. Should
the light still not turn on, refer to the wiring
section and recheck the wire connections.
Detection distance
to MAX.
Time the light stays on after
detecting motion
Verify the light
switch is in the
Light
Activation:
3 min.