Publicité
Les langues disponibles
Les langues disponibles
DANGER!
PROBLEM
Security light
1. Light switch is o .
does not come
2. Fuse is blown. /Circuit breaker has tripped.
on.
3. Fixture not properly wired to J-box.
4. It is daylight.
5. Motion sensor is pointed in the wrong
6. Air temperature is about the same as a
Light continuously
1. Light sensor is triggered by reflected light
cycles ON and OFF
(strobe e ect).
2. Heat is being reflected from other sources
Light turns on
1. Light may be installed in shadows/dark
during daylight
hours.
Light comes on for
1. Sensor may be triggered by a small
no apparent reason.
2. Hot air (dryer vent, car exhaust, etc.) may
Light stays on
1. Motion sensor may be picking up a
continuously at
night.
2. Manual override may be activated.
Light flashes on
1. The TIMER control knob is set to TEST.
for 20 seconds at
a time, day or
night.
REPLACEMENT PARTS LIST: Hardware Kit: ZH-SE1400-F02
Need Help?
Good Earth Lighting
Good Earth Lighting
Troubleshooting Guide
Before doing any work on the fixture, shut o power supply
at the circuit breaker panel to avoid electrical shock.
POSSIBLE CAUSE
direction.
person's body temperature and the motion
sensor cannot "see" the person.
from the security light itself.
and may be triggering sensor on and o .
area.
animal or passing car.
be triggering the sensor.
continuous flow of warm air from an
air vent, dryer vent, or heat reflecting o a
surface.
Please visit our website at: https://goodearthlighting.com/contact-us or call the Customer Care Center
1-800-291-8838, 8:30 a.m.-5 p.m., CST, Monday-Friday.
1400 East Business Center Drive, Ste. 108 Mount Prospect, IL 60056
®
is a registered trademark of Good Earth Lighting, Inc. © 2024 Good Earth Lighting, Inc. REV03.24
®
CORRECTIVE ACTION
1. Turn light switch on.
2. Replace fuse./Turn the circuit breaker back on.
3. Reinstall light fixture.
4. Recheck at night.
5. Readjust motion sensor.
6. Decrease the RANGE control setting.
1. Change the position of the light head and aim light
away from the reflecting surfaces.
2. Decrease the RANGE control setting.
1. Light is operating as it was designed. Use manual
override if necessary.
1. Decrease the RANGE control setting as necessary.
2. Increase the RANGE control setting as necessary.
1. Reposition the motion sensor.
2. Wait until next day for internal dusk-to-dawn sensor
to detect next dusk-dawn cycle. Once light is
detected, this will allow motion sensor to return to
controlling the fixture.
1. Set the TIMER control knob somewhere between
1 and 10.
Printed in Vietnam
11
Publicité
