Good Earth Lighting SE1400-BP2-07LF1-G Mode D'emploi page 5

4 WAYS
TO MOUNT:
PLUG IN
WALL MOUNT
EAVE MOUNT
BOX MOUNT
Locate the key hole slots on the bottom of the fixture. Lift the fixture up to the mounting
3
screws and simultaneously guide the screw heads through the large round ends of the key
hole slots. Slide the fixture until the screw heads are captured in the key hole slots. Plug
fixture into electrical outlet.
Plug-In Installation
Prepare the fixture
Use pliers to remove one of the knock-out
1
openings located on either side of the fixture
near the bottom.
Measure: Select a mounting location. Locate the open key holes
2
on the back of the fixture, measure the center to center distance
between the key holes, transfer that measurement to the
mounting surface and mark the location of the drill holes on the
surface. Attach the foam gasket so that the embedded holes line
up with the marked locations.
2a
Masonry: For mounting onto brick or masonry, drill a 3/16 in. diameter hole
deep enough to accommodate in the masonry anchor. Place the masonry
anchors into the pilot holes and tap them into place until flush with surface.
Drive the long screws into the anchor leaving 3/8 in sticking out above the
surface.
2b
Wood: If mounting onto wood surface, drill a small diameter pilot hole and
drive provided wood screws into the surface until 3/8 in. of the screw
sticking out above the surface.
MASONRY
2a
3/16 in.
4,8 mm
Masonry bit
WOOD
1/16 in.
2b
1,6 mm
Measurement
3/8 in
5