Good Earth Lighting SE1400-BP2-07LF1-G Mode D'emploi page 7

3
Connect the newly exposed fixture wires to the wires inside the junction box using
the provided wire nuts. Connect black supply lead with the black fixture wire and
white supply lead with the white fixture wire using the wire nuts. Secure the wire
nuts properly to prevent the wire from coming loose.
Fasten the mounting screw
5
IMPORTANT
THE PIR CONTROL PANEL SHOULD FACE DOWNWARD TOWARD THE GROUND FOR EASY ACCESS.
Direct Wire Installation
Tuck the wires into the junction box
4
AIM THE PIR SENSOR TOWARD THE INTENDED DETECTION AREA.
Carefully, tuck the connection wires and the
joined connectors into the junction box
behind the mounting strap.
Align the center hole of the fixture and the
mounting strap. Insert the long mounting
screw and fasten it until the light is secure
to the junction box.
CAUTION
DO NOT PINCH WIRES WHEN
TIGHTENING DOWN.
DO NOT OVER TIGHTEN.
7