Electrolux AEG CG 6200 Mode D'emploi page 48

All manuals and user guides at all-guides.com
g
The coffee is not hot
• The cups have not been preheated.
0 Pre-heat the cups by rinsing them in
hot water or leaving them for at least
20 minutes on the heated cup rack (H)
(see „Tips for making hotter coffee",
page 39).
The coffee is not creamy enough
• The coffee is ground too coarsely.
0 Turn the knob for setting the grinding
texture one click anticlockwise whilst
the grinder is grinding beans for the
preparation of next coffee (see „Set-
ting the grinding texture", page 42).
• Wrong type of coffee.
0 Use a type of coffee for fully auto-
mated espresso makers.
The coffee runs out too slowly
• The coffee is ground too finely.
0 Turn the knob for setting grinding tex-
ture one click clockwise whilst the
grinder is grinding beans for the prep-
aration of next coffee (see „Setting the
grinding texture", page 42).
The coffee runs out too quickly
• The coffee is ground too coarsely.
0 Turn the knob for setting grinding tex-
ture one click anticlockwise whilst the
grinder is grinding beans for the prep-
aration of next coffee (see „Setting the
grinding texture", page 42).
The coffee flows out of only one of
the dispensers
• The dispenser holes are blocked.
0 Scrape off the dry coffee residues with
a needle (Fig. 29).
When the knob for steam and hot
water is turned, no steam comes out
of the steam nozzle
• The holes in the steam nozzle and the
inner part of the steam nozzle are
clogged.
0 Clean the holes in the steam nozzle
and the inner part of the steam nozzle
(see „Cleaning the steam nozzle",
page 41).
48
When the or function is
selected, the appliance does not
deliver coffee, but only water
• The ground coffee may be blocked in
the ground coffee filler.
0 Remove the ground coffee inside the
filler using a knife (see „Using pre-
ground coffee", page 40) (Fig. 22). Then
clean the brewing unit and the inside
of the appliance (see „Cleaning the
brewing unit", page 44)
When the button is pressed, the
appliance does not switch on
• The main switch at the back is not
switched on (fig. 8) or the appliance is
not plugged in.
0 Check that the main switch is in the "I"
position and that the power cable is
plugged into the mains socket.
The brewing unit cannot be removed
for cleaning
• The appliance is on. The brewing unit
can only be removed if the appliance is
off.
0 Turn the appliance off and remove the
brewing unit (see „Cleaning the brew-
ing unit", page 44).
3
Important: The brewing unit can only
be removed if the appliance is turned
off with the ON/OFF key
front. It should not be disconnected
from the mains. Attempting to
remove the brewing unit when the
appliance is on may cause serious
damage.
The coffee does not run out from
the dispenser outlets, but from
around the sides of the service door
• The holes in the dispenser outlets are
clogged with dry coffee.
0 Remove the dried coffee with a needle
(Fig. 29).
• The tilt compartment (R) inside the ser-
vice door is blocked and cannot swing.
0 Thoroughly clean the tilt compartment,
particularly near the hinges, to ensure
they are free to swing smoothly.
at the