Parkside PASL 4000 B3 Instructions D'utilisation Et Consignes De Sécurité page 9

Note: Charge the product at least once a month, if
it is to remain unused for an extended period of time.
Note: If the product has not been charged for an
extended period of time (approx. 2 months), you
could find that the integral rechargeable battery
has entered a dormant state. Charge and discharge
the product a number of times in succession to
reactivate the integral rechargeable battery.
Note: You can choose to charge the product directly
via the SELV adaptor
12
Before charging, switch the product off (press
ON/OFF switch
3
To charge the product via SELV adaptor
directly, remove the red rubber cover at the back
of the product, connect the USB cable
the USB connector of the SELV adaptor
and then connect the USB (type C) connector
on the USB cable
11
socket of the LED torch.
6
To charge the product via the charging station,
connect the USB cable
of the SELV adaptor
USB (type C) connector on the USB cable
to the USB (type C) input socket of the charging
station . Then place the product into the charg-
10
ing station to charge the product (see fig. B).
Note: The power indicator of the charging
station will turn to red light when electrical
9
power is connected. It will light up red contin-
uously until the power is disconnected.
Note: The product is fitted with an overcharge
protection circuit. Despite this, you should dis-
connect the LED inspection lamp from the power
supply after the charging process is complete.
Note: The green charging indicators (LED torch)
will light up and flash during charging. There
4
are 4 indicator lights showing the charging
progress (approx. 25 %/50 %/75 %/100 %).
When the indicator continually light on mean
the represented charging progress was finished.
When charging is complete, all indicator light
up without flashing. Pull the SELV adaptor
out of the socket. Disconnect the SELV adaptor
from the product to prevent the rechargeable
battery from discharging.
or via the charging station.
).
12
with
11
12
to the USB (type C) input
with the USB connector
11
and then connect the
12
12
Use
CAUTION! RISK OF ACCIDENT! Always
store and secure the product in such a way that there
is no risk of injury from or damage to the product.
Note: The product may be secured with the fold-
out hook or by securing it to a flat, ferromagnetic
5
surface using the magnetic base
at the back. You can tilt the product up to 180 °
7
on the magnetic base
CAUTION! Please note the position of your hands
whilst turning the magnetic base
pinching your fingers (see fig. D).
Operation
Fully charge the product as described in the
section "Charging the product".
The product can be operated in 3 different
modes, select these by:
Repeatedly pressing the ON/OFF switch
Press once:
11
Press twice:
Press three times: Switches the side light
Press four times:
Fixing the product
The product can be used in 2 ways without having
to hold it in your hand:
Hold the magnet
base against a metallic magnetic surface.
8
The product remains in this position.
Fold out the fold-out hook
the product from a suitable suspension point.
The fold-out hook
360 degree.
12
Note: When hanging up the product, it must be
ensured that the selected location is suitable for
the weight of the product.
or the magnet
8
.
8
to prevent
8
The side light lights up
2
with white light.
The side light turns to
2
UV light mode.
off and switches on the
spotlight .
1
Switches off the product.
at the back or the magnetic
7
to suspend
5
can be turned through
5
GB/IE/NI
.
3
2
9