Parkside PASL 4000 B3 Instructions D'utilisation Et Consignes De Sécurité page 7

Charging time:
Light on time:
Protection class:
SELV adaptor:
Information Value
Manufacturer's OWIM GmbH
name or trade & Co. KG
mark, commercial HRA 721742
registration number Stiftsbergstraße 1,
and address: 74167 Neckarsulm,
GERMANY
Model identifier LC-H050100EU
Input voltage 100–240
Input AC 50/60
frequency
Output voltage 5.0
Output current 1.0
Output power 5.0
Average active 73.7
efficiency
No-load power 0.08
consumption
Protection class
II/
Protection type IP20 (use in dry
location only)
Charging station:
Input:
Model:
Scope of delivery
1 LED torch
1 SELV adaptor
1 Charging station
2 Screws
(ø approx. 4 mm)
approx. 6–8 hours (with
included SELV adaptor)
approx. 3.5 hours for the
side light and 8 hours for
the spotlight (when the re-
chargeable battery is fully
charged)
III/
Unit
V∼
Hz
V
A
W
%
W
5 V , 1 A
SC-001
2 Dowels
(ø approx. 6 mm)
1 Drill template
1 USB cable
1 Operating instructions
Safety instructions
LIFE AND RISK OF ACCIDENTS
FOR INFANTS AND CHILDREN!
Never leave children alone and unsupervised
with the packaging material. There is always
a risk of suffocation if children play with the
packaging material. Children often underesti-
mate risks. Always keep children away from the
packaging material. This product is not a toy.
This product can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction con-
cerning use of the product in a safe way and
understand the hazards involved. Children shall
not play with the product. Cleaning and user
maintenance shall not be made by children
without supervision.
This product is not a toy and should be kept
out of the reach of children. Children are not
aware of the dangers associated with handling
electrical products.
Do not use the product if you detect any kind
of damage.
CAUTION! DANGER OF
EXPLOSION! Do not operate the
product in potentially explosive
environments in which there are inflammable
vapours, gases or dusts.
Protect the product from moisture and damp.
Never immerse the product in water or other
liquids!
Connect the product to a properly installed
mains socket only. The voltages in each case
must comply with information given in the
section "Technical data".
Ensure that the electrical socket is easily ac-
cessible so that you can pull the plug quickly
out of the socket if necessary.
Do not carry out any modifications or repairs
to the product yourself. The LEDs cannot and
must not be replaced.
DANGER TO
GB/IE/NI 7