Foppapedretti Circle Notice D'utilisation page 50

• ENGLISH •
INSTALLATION IN THE VEHICLE
☞ NOTE: before use, check that the ISOFIX connectors are correctly attached on both
sides, when pulling the car seat, they must not detach.
CAUTION: Before every journey, make sure that the rotating part of child seat is fully
engaged by trying to turn the seat around in both directions.
Place the child into the car seat. Adjust the headrest correctly, position the harness
correctly and attach the buckle, finally tighten the harness (fig. 55).
5.3 REMOVING THE CAR SEAT FROM THE VEHICLE
Loosen the Top Tether belt to reduce the fixing tension (fig. 54). Unhook the belt
anchoring carabiner. At the same time press the ISOFIX release buttons and retract the
ISOFIX connectors (fig. 56). Remove the car seat from the vehicle.
5.4 INSTALLATION IN THE FORWARD-FACING POSITION (Children between 100
and 150 cm in height, 3-point seat belt or ISOFIX + 3-point seat belt)
It is recommended that you use the 5-point harness for as long as possible. When the
growing child reaches a height of 100 cm, the car seat must be transformed for use
with children between 100 and 150 cm in height. In this configuration, it is necessary to
remove the 5-point seat belt (harness) supplied with the car seat.
Remove the harness.
Ruotare la seduta nella direzione di marcia. Rotate the seat into the forward-facing
position. Place the seat so that it is in the forward-facing position (fig. 57 e 58).
Make sure that it is locked.
If the car seat is not equipped with the ISOFIX anchoring system, you can use only
the 3-point seat belt for the installation.
Mode A - INSTALLING WITH 3-POINT SEAT BELT TOGETHER WITH ISOFIX
CONNECTORS
Attach the ISOFIX connectors (cfr. par. 4.6.1).
The indicator on both brackets will turn green, confirming that they have attached
(fig.59).
Ensure that both brackets are correctly fastened. Shake the car seat to be sure it is
correctly fixed in place. Push the car seat against the passenger seat, making sure that
both ISOFIX connectors are extended in the same position. There must not be any
space between the backrest of the passenger seat and the car seat.
Place the child into the car seat. Adjust the headrest to the appropriate height.
Pull the vehicle's seat belt and, running it across in front of the child, attach the buckle
of the vehicle 's seat belt, inserting the tip into the buckle (fig. 60). A "click" will indicate
50