Foppapedretti Circle Notice D'utilisation page 46

4.6.1 INSTALLING THE ISOFIX SYSTEM
Press the ISOFIX buttons located on both sides of the seat and extend the ISOFIX
connectors as much as possible (fig. 18 e 19).
Insert the two ISOFIX connectors in the appropriate guides: a "click" will indicate that
they have been inserted and that the ISOFIX connectors are attached on both sides
(fig. 20).
WARNING! The ISOFIX connectors are properly anchored when the respective buttons
are green (fig. 21)
Push the car seat against the backrest of the passenger seat by applying even pressure
on both sides. Shake the car seat to make sure it is firmly attached and check again that
the ISOFIX safety buttons are green (fig. 22).
4.6.2 REMOVING THE ISOFIX SYSTEM
Push the car seat against the backrest of the passenger seat (fig. 23).
At the same time press the ISOFIX release buttons and retract the ISOFIX connectors
(fig. 24).
4.7 ADJUSTING AND USING THE TOP TETHER BELT
Grasp the Top Tether belt and, if necessary, lengthen the strap by pressing the
appropriate locking button, extending it to the desired length (fig. 25).
Attach the fixing device of the "Top Tether" to the anchoring point indicated in the
vehicle user manual (fig. 27). Check that this icon is present inside the passenger
compartment:
Tighten the Top Tether belt, pull the loose belt from the free end until it is sufficiently
tight. A special indicator on the adjuster will turn green, to indicate that the belt has
been tightened correctly (fig. 28).
Check that the Top Tether belt is correctly fastened before starting the vehicle.
FORWARD-FACING (Children between 76 and 105 cm), ISOFIX + Top Tether
• Fasten the Top Tether belt to the headrest of the vehicle passenger seat with the
Velcro strap, as shown in the figure 29a, 29b, 29c.
• Hook the tab into the buckle of the Top Tether belt (fig. 30a, fig.30b). A click will
indicate successful hooking. Grasp the Top Tether belt and, if necessary, lengthen
the strap by pressing the appropriate locking button, extending it to the desired
length (fig. 25). Attach the upper fixing device of the "Top Tether" to the anchoring
point indicated in the vehicle user manual (fig. 26, 27).
• Tighten the Top Tether belt, pull the loose belt from the free end until it is sufficiently
tight. A special indicator on the adjuster will turn green, to indicate that the belt has
• ENGLISH •
INSTALLATION IN THE VEHICLE
46