Foppapedretti Circle Notice D'utilisation page 47

been tightened correctly Check that the Top Tether belt is correctly fastened before
starting the vehicle.
• Press the red button on the Top Tether belt buckle to release the Top Tether belt and
be able to rotate the seat towards the vehicle door, a continuous "beep" will indicate
that the Top Tether buckle is not engaged (fig 31a, fig.31b).
• The "beep" alarm sounds for 3 minutes.
• After placing your child in the car seat or taking them out, rotate the seat into the
rear-facing position (installation for children 40 to 105 cm tall) or the forward-facing
position (installation for children 76 to 105 cm tall) and attach the Top Tether buckle,
the audible alarm will go off.
• The Top Tether belt is guaranteed to work even without the use of the battery, but it
is recommended to insert the battery to allow the sound check to make sure that the
car seat has been installed correctly.
CAUTION: when installing the car seat with children between 40 and 105 cm or
between 76 and 105 cm, check that the Top Tether belt is correctly fastened before
starting the vehicle.
4.8 REMOVING AND INSTALLING THE HARNESS
Completely loosen the shoulder straps, see paragraph "4.2 How to adjust the harness".
Pull the handle on the headrest and, keeping it pulled, raise or lower the headrest,
adjusting it according to the child's height (fig. 9).
Press the red button on the central buckle to release the shoulder straps (fig. 1).
Unhook the press studs on the sides of the backrest fabric, place the shoulder straps on
the back of the fabric. Place the buckle tips on the seat sides, in the lower part.
Position the backrest fabric correctly and attach the press studs. Remove the buckle
protection padding and store it in a safe place or place it behind the backrest fabric, with
the chest straps. Lift up the seat cover fabric, pulling it out of the harness adjustment
device and lift up the inner padding, pulling it out of the harness adjustment device,
pulling carefully and gently.
Unthread the buckle inwards from the slots in the fabric and padding, open up the
container compartment door and put the buckle back inside. Close the compartment.
Reposition the internal padding correctly on the seat. Reposition the seat lining
correctly, fitting the fabric around the harness adjustment device. Reposition the lining
correctly along the outer edge of the car seat (fig.35/ fig.41).
• ENGLISH •
INSTALLATION IN THE VEHICLE
47