Toshiba 24 WL2C Serie Guide De Mise En Marche Rapide page 3

1
Inserting the batteries into the remote
Remove the back cover to reveal the battery compartment. Insert two 1.5V
size AAA batteries. Make sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on. A message will be displayed on the
screen when the batteries are low and must be replaced.
2
Connections
Antenna
Connect the antenna cable/s to your TV.
rear side of the TV
HDMI connection
rear side or rear-left
side of TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you connect
the set to the mains. Plug the power cable to the mains socket outlet.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
After unpacking, allow the TV set to reach the ambient room temperature before you
(**)
connect the set to the mains. Plug the adaptor to the mains socket outlet.
IMPORTANT: The TV set is designed to operate on a 12V DC supply. For this, an adaptor is used which gives
12 V voltage. Connect this adaptor to a system that supplies 100-240V AC, 50/60Hz.
In order to supply the power via the cigarette lighter socket of your vehicle, plug one end of the supplied
cigarette lighter adaptor cable into the vehicle socket and plug the other end of the adaptor cable into the DC
12V terminal on the back side of the TV.
Important safety information
Plug the appliance to a grounded outlet. Always use the grounded
power cord supplied with your product. Manufacturer is not
responsible for any damage caused unearthed usage.
As a safety precaution, a three-wired grounding plug is given with
the product. Please do not make any change on the grounding
plug. Always use earthed socket outlet for product.
(**) Limited Models Only
satellite
dish
aerial /
cable TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control. Or press the centre of the
control switch inwards consecutively until the sources
list is displayed.
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control. Or press the control
button to display the function options menu and then
press the button consecutively to move the focus to
Source option. Press and hold the button for about 2
seconds to activate this option. The icon colour of the
option changes when activated. Then press the button
once again to display the sources list. Scroll through
the available sources by pressing the button.
English - 1 -
-or-
To Power Input, DC 12 V
terminal
AC adaptor