Publicité
Les langues disponibles
Les langues disponibles
C Securing the Oven in the Opening
Drilling the Pilot Holes and
Mounting the Oven
NOTE: Before drilling the pilot holes, make sure
the oven is pushed as far back into the opening
as it will go and is centered.
a. Drill through the mounting holes in front frame,
for the #8 screws provided.
Mounting
Hole
Locations
(Hole Locations
May Vary)
WARNING:
screws must be used. Failure to
do so could result in the oven falling
out of the cabinet, causing serious
injury.
b. Secure the oven to cabinet with screws provided.
NOTE: If the cabinet is particle board, you must use
#8 x 19 mm (3/4") particle board screws. These may
be purchased at any hardware store.
Installation Instructions
The screws must be a
minimum of 6 mm (1/
4") from the front of
the cutout.
Mounting
6
Publicité
