Microlife OXY 210 Mode D'emploi page 8

Description Symptom/
Possible causes
The device cannot 1. No batteries or
be powered on. low battery
power.
2. Batteries are
not installed
correctly.
3. The device
may be
damaged.
The display 1. The device is
suddenly switches automatically
off. powered off,
when no
signal was
detected after
10±2
seconds.
2. The battery
power is too
low to operate.
6
10. Cleaning and disinfecting
Solutions
Use an alcohol swab or cotton tissue moistened with
alcohol (70% Isopropyl) to clean the silicone that touches
1. Replace the
the finger inside of the device. Also clean the finger being
batteries.
tested using alcohol before and after each test. Allow the
2. Remove
device to dry thoroughly before use.
and rein-
stall the
Never use abrasive cleaning agents, thinners or
batteries.
benzene for cleaning and never immerse the
3. Contact
device in water or other cleaning liquids.
your local
11. Guarantee
Microlife-
Customer
This device is covered by a 2 year guarantee from the date
Service.
of purchase. During this guarantee period, at our discre-
1. Normal. tion, Microlife will repair or replace the defective product
2. Replace the free of charge.
batteries. Opening or altering the device invalidates the guarantee.
The following items are excluded from the guarantee:
 Transport costs and risks of transport.
 Damage caused by incorrect application or non-
compliance with the instructions for use.
 Damage caused by leaking batteries.
 Damage caused by accident or misuse.
 Packaging/storage material and instructions for use.
 Regular checks and maintenance (calibration).
 Accessories and wearing parts: Battery.
Should guarantee service be required, please contact the
dealer from where the product was purchased, or your local
Microlife service. You may contact your local Microlife
service through our website: www.microlife.com/support
Compensation is limited to the value of the product. The
guarantee will be granted if the complete product is
returned with the original invoice. Repair or replacement
within guarantee does not prolong or renew the guarantee
period. The legal claims and rights of consumers are not
limited by this guarantee.
12. Technical specifications
Model: Pulse Oximeter JPD-500E
Type: OXY 210
Display: OLED display
Display range: Oxygen saturation: 35 ~ 100%
Pulse rate: 25 ~ 250 bpm
Resolution: Oxygen saturation: 1%
Pulse rate: 1 bpm
Measurement Oxygen saturation:
precision:
±3% (70 – 100%)
No requirement: (≤ 69%)
Pulse rate: ± 2 bpm