Wetrok Scuba Mode D'emploi page 20

Read this before commissioning!
The equipment detailed in this manual is suitable for commercial use, for example in hotels, schools, hospitals, factories, shops, offices, and
rental businesses.
Carefully unpack and inspect your new vacuum for shipping damage. Each unit is tested and thoroughly inspected before shipping. For
instructions regarding any shipping damage, contact your Wetrok representative.
This operator's manual has important information for the use and safe operation of the vacuum cleaners detailed in this manual. Read this
manual carefully before starting the machine. Keep this manual available at all times and instruct all operators to read this manual. If instruc-
tions are not followed, an injury may occur or equipment, furniture or buildings may become damaged.
The contents of this manual are based on the latest product information available at the time of publication. Wetrok reserves the right to
make changes or improvements to its machines or components without notice.
The products that are covered by this instruction manual are intended for commercial use.
WARNING
• USE ONLY genuine Wetrok replacement filters to ensure optimal performance, improved indoor air quality and maintain a valid vacuum
warranty.
• DO NOT vacuum with a frayed, worn, or damaged cord.
• DO NOT vacuum liquids or expose the vacuum to rain or water. The vacuums in this manual are for dry use only and are not to be used or
stored outdoors in wet conditions.
• DO NOT vacuum hazardous dust or toxic materials.
• DO NOT use vacuums to pick up flammable or combustible materials and do not store them in the filter bay.
The equipment detailed in this manual is not intended for use by persons (including children) with reduced physical, sensory, or mental capa-
bilities, or lack of experience.
If the vacuum stops running, it may be due to the motor's thermal safety switch tripping due to a lack of airflow through the vacuum. Immedi-
ately turn off the vacuum and inspect for a blockage and verify the condition of the filter bag and change or empty as required.
The vacuum will require several minutes to cool down to a safe operating temperature. When this temperature is attained, the thermal switch
will reset and the vacuum will be able to be used in a normal manner.
MOTOR
Electric thru-flow vacuum motors must never be used in applications in which wet or moist conditions are involved, where dry chemicals or
other volatile materials are present, or where airflow may be restricted or blocked. Such motors are designed to permit the vacuumed air to
pass over the electrical wiring to cool it. Therefore, any liquid (including water), dry chemical, or other foreign substance which would come
in contact with electrical conductors could cause combustion (depending on volatility) or electrical shock. Failure to observe these precau-
tions could result in property damage and severe personal injury, including death in extreme cases.
ELECTRICAL
The vacuums as described in this manual, unless otherwise noted, are designed to operate on 220VAC – 240VAC power supply at 50Hz / 60Hz.
The vacuums as described in this manual are a Class I appliance, unless otherwise noted.
The vacuum cleaners described in this manual are equipped with a thermal protection device. The integrated thermal switch will remove
power from the vacuum motor in the event excessively high operating temperatures are detected. This condition is normally the result of a
blocked vacuum passage, clogged or full filters.
Should a thermal trip take place, immediately turn off the vacuum and inspect for a blockage and verify the condition of the filter bag and
change or empty as required.
The vacuum will require several minutes to cool down to a safe operating temperature. When this temperature is attained, the thermal switch
will reset and the vacuum will be able to be used in a normal manner.
19