Filter Maintenance - Wetrok Scuba Mode D'emploi

Proper vacuuming motion for large areas
1. Begin with the wand parallel to your body.
2. Draw the top of the wand in toward your waist and twist at the waist walking backward or forward, in a
side-to-side motion. The motion is similar to mopping and keeps the upper body and arms from tiring.

Filter Maintenance

1.Empty and inspect 2. To replace the Inter-
the filters every time cept Micro Filter, slide
you start and finish filter into the Cloth Filter
vacuuming. Replace if and secure into vacuum.
necessary. A clogged and
dirty filter restricts airflow
and results in reduced
suction and overheating.
Following the above instructions is the best way to prolong the life of the vacuum. DO NOT TRY TO WASH or VACUUM the Exhaust Filters. Doing so will fracture the
filter media, greatly decreasing its efficiency.
NOTE
If using a high filtration disc in place of the foam media, check it every two to three weeks. When the disc becomes discolored, replace it with a new disc.
The life of the high filtration disc will depend greatly on the use and care of the Intercept Micro Filter and Cloth Filter. For best results replace pleated dome
filter every 6 months.
3. Once a month, or 4. Once a week, or as
as necessary, hand or necessary, clean the
machine wash the Cloth Dome Filter.
Filter and let it line dry, do
not put it in the dryer. a. First, remove the
Intercept Micro Filter and
Cloth Filter. Reach into
the vacuum body and
twist the Dome Filter
from the motor.
18
b. Shake it out, rinse 5. Once a month (or
it and let it air dry more often if necessary)
thoroughly. clean the
exhaust diffuser.
c. Firmly snap the top
piece of the Dome Filter a. Rinse (Figure), air dry,
into place and return the foam filter
diffuser at the bottom of
the vacuum below the
motor.