Warning!
Prolonged use of a tool will subject the user to vibration
and shocks that could lead to Raynaud's syndrome or
Carpal tunnel syndrome.
This condition reduces the ability of the hand to sense
and regulate temperature, causes numbness and a
sensation of heat, and can cause damage to the nervous
and circulatory systems and to necrosis.
Not all factors that lead to Raynaud's syndrome are
known, but cold water, smoking, and illnesses that
impact the blood vessels and the circulatory system
and severe or long-lasting exposure to vibrations are
known to be factors that contribute to the development of
Raynaud's syndrome. Observe the following instructions
to reduce the risk of Raynaud's syndrome and Carpal
tunnel syndrome:
• Wear gloves and keep your hands warm.
• Make sure the device is well maintained. A tool with
loose components or with damaged or worn dampers
is prone to increased vibration.
• Always hold the handle firmly, but do not grip it con-
tinuously with excessive pressure. Take breaks often.
All of the precautions indicated above cannot exclude the
risk of Raynaud's syndrome or Carpal tunnel syndrome.
Therefore, it is advisable in case of long-term or regular
use to monitor the condition of your hands and fingers
closely. Seek medical attention immediately if any of the
above symptoms appear.
Safety instructions
Attention! Read all instructions con-
tained herein. Failure to observe the fol-
lowing instructions may result in electric
shock, burns and/or severe injury. The
term 'power tool' used in the following
includes both mains-operated tools (with
mains supply) and battery-operated tools
(without mains supply).
KEEP THESE INSTRUCTIONS CAREFUL-
LY!
1) Instructions regarding to safe handling
a) Wear goggles or properly fitted safety
glasses, sturdy closed shoes with non-slip
soles, gloves, snug-fitting work clothes
and ear protectors (ear plugs or ear muf-
flers).
b) Minors should never be allowed to use an
electric trimmer. Never lend or rent your
electric trimmer without these operating
instructions.
c) Do not use the trimmer if other persons,
GB | Operating Instructions
2) Maintenance
GB-4
above all children, or animals are near the
working area.
d) Work calmly and stay alert. Operate the
trimmer under good visibility and daylight
conditions only.
e) Before using the machine, the line and
extension cords have to be checked for
signs of damage or ageing. Do not use
the trimmer when the cords are damaged
or worn.
f) Do not use damaged power supply cords,
extension cords, couplings, plugs or cut-
ting heads.
g) Careless use can cause injuries to hand
and feet by the rotating cutting elements.
Do not switch on the unit when hands or
feet are near the cutting elements.
h) Never use metal cutting devices.
i) Only use original spare parts.
j) Remove the battery before testing, clean-
ing or working on the machine and when
it is not in use;
k) Inspect cooling air slots on the motor
housing at regular intervals for clog-ups
and clean as necessary.
a) Children should be under supervision
to ensure that they do not play with the
device.
b) Any other work should be performed by
your dealer.
c) Never use metal cutting devices.
d) Clean the cutting head at regular inter-
vals.
e) Check the condition of the cutting head at
frequent intervals. If the behaviour of the
cutting head changes (vibration, noise),
check immediately as follows: Switch off
the trimmer, hold it firmly and bring the
cutting head to a standstill by pressing it
against the ground. Then disconnect plug
from power supply. Check condition of cut-
ting head - look for cracks.
f) Have a damaged cutting head replaced
imme-diately - even if it only has super-
ficial cracks. Never attempt to repair a
damaged cutting head.
g) Inspect cooling air slots on the motor hous-
ing at regular intervals for clog-ups and
clean as necessary.