LENCO BTP-200BK Mode D'emploi page 8

1. The Bluetooth Speaker will send tones sound from speaker by every
some minute. When you heard this reminder, please connect the
device to the USB power for charging, if you still want to use the device.
2. If not, the Bluetooth Speaker will power Off automatically when the
battery is keeping low energy level in some minutes.
3. In this case, the device cannot be turned On, until you recharging the
battery at least 10 ~ 15 minutes, because the rechargeable battery has
not enough energy.
4. Press and hold "
enough energy if you want.
M. Connecting two speakers and a BLUETOOTH device for the Stereo
pairing function
Activate the stereo pairing function:
1. Bring two speakers within 1 m of each other, and then turn on each
unit.
2. Press and hold the "
are heard on one unit, the "Bluetooth LED (7)" will fast blinking and
waiting for stereo pair connection. (This unit will default as host and
left channel device)
3. And press and hold the "
are heard on the other unit, the "Bluetooth LED (7)" will fast blinking
and searching for stereo pair host unit. (This unit will default as slave
and right channel device)
4. Two devices are under stereo pairing, a series of tones should sound
from both devices in seconds;
5. And, the right device's "Bluetooth LED (7)" should switch to slow
blinking and this device could not found by the mobile device since it
already paired with slave device of Bluetooth speaker.
6. And, the Left device's "Bluetooth LED (7)" should switch to fast
blinking for waiting Bluetooth pairing with mobile device.
7. Then activate the Bluetooth function in your mobile device, open and
enter to Bluetooth searching mode, the mobile device should show
one of "Lenco BTP200"
stereo pairing function.
8. This stereo pairing procedure is not required once stereo pairing
function is activated with both speakers; two speakers will stereo
pairing automatically when each time you turn on them together.
Besides, you can disable the stereo pairing function by using the
following methods.
Disable the stereo paring function on two speakers:
1. In speakers power on mode, short press the "
(2)" button to turn On the device after charged with
and " buttons at the same time until tones
and
instead of two in list, choose it for start the
8
" buttons at the same until tones
and " buttons at