Publicité
Les langues disponibles
Les langues disponibles
Front panel
F-336B
Diamond
dermabrasion
Instructions of use
1. Connect the power supply via the rear panel.
2. Turn on the "POWER" button.
3. Correctly connect one side of the pipe to the rear
panel as indicated in the sketch.
4. Connect the opposite side of the pipe to the vacuum
handle.
5. Place the correct diamond head in the handle. There
are nine types of diamond heads.
Ø 22 MM
Body. Suitable for acne, knees, elbows
D100
and areas with stretch marks
D180
Ø 19 MM
Face. Suitable for large spots, pores,
D180
aging sun exposure
D220
Ø 15 MM
Scars, fine lines and various imperfec-
D100
tions
D200
D250
Ø 8 Y 6 MM
Eyes and both sides of the nose.
D200
Wrinkles, acne, pimples and
D250
blackheads
6. Check that the foam filter is in its proper position in
the handle.
7. Check that the metal filter is in its proper position in
the handle.
Start/Pause
8. You can adjust the suction effect by turning the
regulator.
9. You can adjust the suction effect by covering or
uncovering the hole in the side of the handle with your
finger.
10. Once you have finished, first turn off the unit by
pressing the "POWER" button.
Cautions
•
Do not leave the handle on the same part of skin for
too long since it can cause injuries.
•
Avoid using it on irritated skin.
•
The following skin areas are unsuitable for these
treatments: skin tumors, moles, birthmarks,
angiomas, lips, eyes, herpes and warts.
•
Do not operate the suction pump for prolonged
periods without cooling time between treatments to
prevent pump overheating and damage to the
machine. Damage caused by overheating of the pump
are not covered by the manufacturer's warranty.
Energy
Timer
Publicité
