Blaupunkt GTt 1000 BP11 Mode D'emploi page 18

GTt 1000 BP11
3. Zatim poslušajte odnos dubokih muških glasova prema
gornjem basu, te odnos od gornjeg basa (kik-bas) prema
dubokom basu. Bas se u idealnom slučaju mora čuti čvrsto
i sa jasnim dubokim basom a muški glasovi ne bi smjeli
djelovati niti preslabo niti prenapeto. Ako je ton u redu,
završili ste s ujednačavanjem. Ukoliko nije, nastavite kao
što je opisano pod 4.) i 5.).
4. Ukoliko se muški glasovi čine prenapeti, ili ukoliko je
duboki bas preslab, trebali biste Crossover regulator
okrenuti malo u smjeru minimuma te nastaviti s usklađi-
vanjem ponovno kod točke 2.).
5. Ukoliko bas djeluje duboko, ali nečisto i treštajuće ili
ukoliko muški glasovi zvuče preslabo, Crossover regulator
treba okrenuti malo u smjeru maksimuma. Osim toga tre-
bate regulator faze (phase) (ukoliko postoji) podesiti tako,
da gornji bas zvuči što je jače moguće. Zatim nastavite
s usklađivanjem pod točkom 2.).
Recikliranje i zbrinjavanje
Molimo Vas da za zbrinjavanje proizvoda koristite
sustave vraćanja i skupljanja koji vam stoje na ras-
polaganju.
Promjene pridržane!
USA
Please read these operating instructions before using
the equipment for the fi rst time.
Safety Notes
Please observe the following safety notes during the instal-
lation and connection.
– Disconnect the negative terminal of the battery before
carrying out installation and connection work.
– Observe the vehicle manufacturer's safety instructions
(regarding airbags, alarm systems, trip computers,
vehicle immobilisers).
– Prior to drilling the mounting holes, make sure that no
cables and parts of the vehicle will be damaged.
– Use cable glands for holes with sharp edges.
– Leave ample clearance between the cables and other
harnesses.
– An incorrect installation can result in malfunctions of the
electronic vehicle systems or your car sound system.
Installation and connecting instructions
Warning! Accident risk!
Do not mount the GTt 1000 BP11 on the rear
shelf, rear seat or at any position which is
open towards the front. Blaupunkt recom-
mends to install the system in the boot (see
Fig. 1). Example connection (see Fig. 2).
18
The GTt 1000 BP11 can be operated in normal as well as in
bridged mode (for further details, please refer to the operat-
ing instructions that came with the amplifi er). In any case,
please observe the RMS output power of your amplifi er.
It must not exceed the RMS power of the GTt 1000 BP11.
Non-compliance with this can cause damage to the product
in the long term.
Note:
We recommend that you operate the GTt 1000 BP11 in
conjunction with our GTA series amplifi ers.
Setting up the subwoofer tube
In order to achieve a balanced sound, we recommend that
you confi gure the amplifi er as follows.
1. First set the volume control to minimum and the cross-
over control to its middle position.
2. Now play some music on your car sound system that
you are very familiar with and that contains some low
bass (e.g. pop music). Now slowly increase the volume
of the subwoofer until you feel that the sound of the
music is well balanced, i.e. the bass is neither too weak
nor overpowering.
3. Now listen to the relationship between deep male voices
and the upper bass and also take note of the relationship
between the upper bass (kick bass) and the lower bass.
The bass should ideally sound crisp and have a clear low
bass component, and male voices should neither sound
too weak nor should they billow out. If you are happy with
the sound then you are already fi nished with the setup
process. If not, continue as described in points 4 and 5.
4. If male voices seem to billow out or the low bass is too
weak, you should turn the crossover control slightly
towards minimum and then resume making your adjust-
ments as described in point 2 onwards.
5. If the bass sounds low but dirty and booming or the male
voices sound too weak, you should turn the crossover
control slightly towards maximum. Furthermore, you
should set the phase control (if present) so that the upper
bass sounds as powerful as possible. Next, resume making
your adjustments as described in point 2 onwards.
Recycling and disposal
To dispose of the product, please use the available
waste return and collection systems.
Subject to changes!