Publicité
Les langues disponibles
Les langues disponibles
CONNECTING INLET HOSES (for steam dryer models only)
CONNECTING INLET HOSES
To produce steam, the dryer must connect to the cold
water supply. Since the washer must also connect to
the cold water, a "Y" connector is inserted to allow
both inlet hoses to make that connection at the same
time.
NOTE: Use new inlet hoses; never use old hoses.
1. Turn the cold water faucet off. Remove the washer
inlet hose from the washer fill valve connector
(cold).
2. Ensure the rubber flat washer is in place and attach
one female coupling of the short hose provided
onto the washer fill valve connector. Tighten by
hand until firmly seated.
3. Attach one male end of the "Y" connector to the
other female coupling of the short hose. Ensure the
rubber flat washer is in place. Tighten by hand until
firmly seated.
4. Insert the filter screen in the coupling of the
washer's inlet hose. If a rubber flat washer is
already in place remove it before installing the filter
screen. Attach this coupling to one male end of the
''Y'' connector. Tighten by hand until firmly seated.
5. Ensure the rubber flat washer is in place and attach
a 4 ft. (1.2 m) to 6 ft. (1.8 m) long water inlet hose
(may need to be purchased separately) to one male
end of the ''Y'' connector. Tighten by hand until
firmly seated.
6. Ensure the rubber flat washer is in place and attach
the other end of the dryer's long inlet hose to the
fill valve connector at the bottom of the dryer back
panel. Tighten by hand until firmly seated.
Installation Instructions
CONNECTING INLET HOSES (cont.)
7. Using pliers, tighten all the couplings with an
additional two–thirds turn.
NOTE: Do not overtighten. Damage to the couplings
may result.
8. Turn the water faucet on.
9. Check for leaks around the ''Y'' connector, faucet
and hose couplings.
WATER SUPPLY REQUIREMENTS
Hot and cold water faucets MUST be installed within
42 in. (107 cm) of your washer's water inlet. The
faucets MUST be 3/4" (19.1 mm) garden hose-type
so inlet hoses can be connected. Water pressure
MUST be between 10 and 120 pounds per square
inch. Your water department can advise you of your
water pressure.
NOTE: A water softener is recommended to reduce
buildup of scale inside the steam generator if the
home water supply is very hard.
4
Publicité
