GE Profile PTD70GBPTDG Instructions D'installation page 20

REVERSING THE DOOR (OPTIONAL)
B MODELS WITH FABRIC REFRESH
FEATURE
1
Open the door approximately 130°. With a putty
knife, remove the 4 plastic caps located along the
left side of the front panel and set them aside.
2
Remove the bottom screw from each hinge (right
side) and partially insert them into each top hinge
hole on the left side.
NOTE: All 4 front panel hinge screws will now be
in the top hinge holes - 2 on the left and 2 on the
right.
3
Use a small flat blade screwdriver to remove the
harness cover from the front panel.
Harness
Cover
Installation Instructions
Plastic Cap (4)
Left side of
front panel
B MODELS WITH FABRIC REFRESH
FEATURE (cont.)
4
Loosen each top hinge screw on right side.
Remove the door and place it on a protective flat
surface to avoid any damage.
Loosen each
top hinge screw
on right side
5
Remove both the blind plate and the strike plate and
install them in the opposite positions.
Strike
Plate
6
Remove the plastic beauty cover and install it onto
the other side of the front panel.
Beauty
Cover
20
Blind
Plate