Télécharger Imprimer la page

Electrolux SC310 Notice D'utilisation page 68

Publicité

Les langues disponibles

Les langues disponibles

68
www.electrolux.com
Problem
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily. You attempted to re-open
The lamp does not work.
There is too much frost
and ice.
Water flows on the rear
plate of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Possible cause
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The appliance is not level‐
led.
the door immediately after
closing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Door was open too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Solution
Allow food products to cool
to room temperature be‐
fore storing.
Refer to the "Closing the
door" section.
Refer to the installation in‐
structions.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
Close and open the door.
Contact the nearest Au‐
thorized Service Centre.
Refer to the "Closing the
door" section.
Refer to the "Closing the
door" section.
Wrap the food products
better.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
This is correct. Dry the wa‐
ter with a soft cloth.
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.

Publicité

loading