Publicité
Les langues disponibles
Les langues disponibles
64
www.electrolux.com
4.5 Door open alarm
If the fridge door is left open for
approximately 2 minutes, the sound is on
and the alarm indicator flashes.
The alarm stops after closing the door.
4.6 Alarm
In case of cooling issues, power
interruptions or significant temperature
changes inside your appliance, the alarm
indicator lights up red and the sound is
on.
The alarm may light when
you plug the appliance for
the first time.
Refer to the "Troubleshooting" chapter
for more possible causes of triggering
the alarm, and solutions on how to
deactivate it.
4.7 Standby mode
Activate the Standby mode to switch off
the cooling function and therefore lower
the energy consumption of the appliance.
5. DAILY USE
CAUTION!
This refrigerating appliance
is not suitable for freezing
foodstuffs.
5.1 Removing and installing the
door shelf
To remove the door shelf:
1. Hold the left side of the shelf.
2. Lift the right side of the shelf until it
comes free from the fastener.
To activate the Standby mode:
1. Set the temperature for 2°C. Refer to
the "Temperature regulation" section.
2. Press and hold the temperature
regulation button until all temperature
indicators blink 3 times.
If you press the temperature
regulation button while the
Standby mode is on, all
temperature indicators blink
3 times.
You can deactivate the Standby mode by
repeating the above procedure.
During the Standby mode,
the temperature inside the
appliance may rise above
the set 2°C. If that happens
after the mode deactivates,
the alarm indicator lights and
the sound is on. When the
appliance automatically
lowers the temperature, the
alarm indicator and the
sound alarm deactivate.
3. Lift the left side of the shelf and
remove it.
To put the shelf back in:
1. Place the shelf flat on the door.
2. Push two sides of the shelf
downwards at the same time so that
the shelf fits both fasteners.
5.2 Movable shelves
The walls of the refrigerator compartment
are equipped with a series of runners so
Publicité
