Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Fig. G
17
8. After blade installation, the wrench
guide
can be stored on the back of the tool.
10
Fig. H
10
4
To Attach the Edge Guide (Fig. I)
The edge guide can be installed 1 of 2 ways, 45° or 90°.
1. Place edge gude
10
on the cutting cart fence
2. Turn the edge guide lock
Fig. I
11
8
5
18
14
4
and edge
7
.
clockwise to tighten.
11
10
7
Specifcations
Voltage
RPM
Depth of Cut
Blade Size
Arbor Size
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury. Make sure the
switch is in the OFF position.
Installing and Removing the Battery Pack
(Fig. J)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
19
pack with the rails inside the tool and slide it into position
until the battery pack is firmly seated in the case and ensure
that it does not disengage.
To remove the battery pack from the tool, press the release
button
20
and firmly pull the battery pack out of the tool.
Insert it into the charger as described in the charger section
of this manual.
Fig. J
19
Tool Placement (Fig. K)
Place saw on a stable, level surface.
20V
2800
1.25" (32 mm)
7" (178 mm)
5/8" (16 mm)
into the tool, align the battery
20
Publicité
Table des Matières
