Sony RM-VL600T Mode D'emploi page 26

Controlling the Volume of Visual
Components Connected to an
Audio System (continued)
2
While holding % pressed,
press 2 + or 2 –.
To set all volume controls to
AMP
Press 2 + while holding %
pressed.
All Component Select buttons
light up when you press these
buttons, and then turn off
when you release them.
Press and while holding 2 +,
press %.
TV DVD
VCR CD
Volume control setting complete.
TV DVD
VCR CD
GB
26
SAT CBL
TAPE AMP
SAT CBL
TAPE AMP
To set only the audio
components' volume controls
to AMP
Press 2 – while holding %
pressed.
Only AMP lights up when you
press these buttons, and then
turns off when you release them.
Press and while holding 2 –,
press %.
TV DVD
VCR CD
Volume control setting complete.
TV DVD
VCR CD
Visual components are:
TV, video cassette recorder,
analogue cable box, satellite
tuner, DVD player
Audio components are:
CD player, MD player,
cassette deck, amplifier
To cancel setting, press SET.
Note
If you used the Learning function to
programme the 2 +/– or % buttons to
send a signal to a component, the
procedure above will not change the
function of the 2 +/– and % buttons.
SAT CBL
TAPE AMP
SAT CBL
TAPE AMP